Use the power lock switch to unlock or lock all of the doors. The power lock switch is located on the passenger side of the rear cargo door or the tailgate.

Press the power door lock switch when the cargo doors are open and all the doors lock 5 seconds after the cargo doors close. Press the power door lock switch to lock the vehicle doors when the cargo doors close.

1. Remove the two screws on the right D pillar trim panel.
2. Disconnect the wiring connector.



3. Unclip the switch.
4. Remove the switch.

1. Clip the switch into location.
2. Connect the wiring connector.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the two screws into the right D pillar trim panel.

Tighten
Tighten the D pillar trim panel screws to 2 N·m (18 lb in).