Tools Required

J 23523-F Crankshaft Balancer Remover

1. Disconnect the battery negative cable from the battery. Refer to Battery Cable in Engine Electrical.
2. Remove the upper fan shroud from the radiator. Refer to Fan Shroud Replacement in Engine Cooling.
3. Remove drive belt from the vehicle. Refer to Drive Belt Replacement .
4. Raise the vehicle and support with safety stands.
5. Remove the lower fan shroud from the radiator. Refer to Fan Shroud Replacement in Engine Cooling.
6. Remove the crankshaft pulley from the crankshaft.



7. Remove the crankshaft balancer bolt and washer from the crankshaft.



8. Use the J 23523-F to remove the crankshaft balancer from the crankshaft.
9. Remove the J 23523-F from the crankshaft balancer.

Tools Required

J 23523-F Crankshaft Balancer Remover

1. Apply a small amount of clean engine oil the crankshaft balancer.
2. Lightly tap the crankshaft balancer into the crankshaft.
3. Install theJ 23523-F to the crankshaft balancer.
4. Install the crankshaft balancer to the crankshaft.
5. Remove the J 23523-F from the crankshaft balancer.




Important: When installing the crankshaft balancer bolt and washer, make sure take the curved part of the washer is pointed away from the engine.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

6. Install the crankshaft balancer bolt and washer to the crankshaft.

Tighten
Tighten the bolt to 270 N·m (200 lb ft).




7. Install the crankshaft pulley to the crankshaft.
8. Install the crankshaft pulley bolts.

Tighten
Tighten the bolts to 40 N·m (30 lb ft).

9. Install the lower fan shroud to the radiator. Refer to Fan Shroud Replacement .
10. Lower the vehicle.
11. Install the drive belt in the vehicle. Refer to Drive Belt Replacement .
12. Install the upper fan shroud to the radiator. Refer to Fan Shroud Replacement .
13. Connect the battery negative cables to the batteries. Refer to Battery Cable in Engine Electrical.