Steering Column Seal Replacement - On Vehicle Exc. 3500HD

1. Set the front wheels in the straight-ahead position.
2. Set the steering wheel in the LOCK position.
3. Mark the upper to the lower intermediate shaft in order to be sure of proper installation.



4. Remove the shield from the steering gear
5. Remove the nut and the bolt from the upper to the lower shaft connection.
6. Pull the lower shaft out of the upper shaft.



7. Grasp and compress the seal (1).

Remove the seal by pulling the seal away from the dash (2).

1. Slide the seal (1) up the steering column.
2. Align the locating tab on the seal (1) with the notch at the bottom of the dash panel (2) opening.
3. Slightly compress the seal (1) while forcing the seal inward until the retaining collar snaps open on the inside of the cab.
4. Pull the lower shaft up into the upper shaft.
5. Verify that the retaining collar has opened on the inside of the cab 360 degrees.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

6. Install the nut and the bolt to the upper end of the shaft.

Tighten
Tighten the nut and the bolt to 62 N·m (46 lb ft).




7. Install the shield to the intermediate shaft.

Steering Column Seal Replacement - On Vehicle 3500HD

1. Remove the steering column. Refer to Steering Column Replacement .



2. Push the locking ring tabs inward one at a time until the seal (1) separates from the dash panel (2).
3. Note the position of the locating tab directly at the bottom of the locking ring and the dash panel (2) opening.

1. Align the locating tab groove on the seal (1) directly at the bottom of the dash panel (2) opening.

The sheet metals fits into the groove.

2. Force the seal (1) upward and inward until the seal snaps into place.



3. Install the steering column.