3.1. | Drain the oil into a suitable container. |
3.2. | Remove any gasket material from the rear axle housing and/or the rear axle housing cover. |
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the rear axle housing cover bolts in a crosswise
pattern to 40 N·m (30 lb ft).
Tighten
Tighten the rear axle fill plug to 40 N·m
(30 lb ft).
Drain the lubricant into a suitable container.
The sealant is to be applied in the middle of the rear axle housing cover flange and on the inside of all bolt hole openings as shown.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the rear axle housing cover bolts to 47 N·m (35 lb ft).
Important: Allow the sealant to cure for 1 hour before filling the axle with axle lubricant.
Tighten
Tighten the rear axle fill plug to 33 N·m (24 lb ft).