Check the park brake for proper adjustment. Refer to Park Brake Cable Service/Adjustment .

Is adjustment within specifications?

--

Go to Step 2

Go to Step 4

1. Disconnect and remove the park brake linkage travel switch from the actuator.
2. Connect a J 39200 DMM across the park brake linkage travel switch terminals.
3. Measure the resistance.

Is the resistance more than the stated value?

>1 ohms

Go to Step 3

Go to Step 5

Replace the park brake linkage travel switch. Refer to Park Brake Travel Switch Replacement .

Is the repair complete?

--

System OK

--

Adjust the park brake. Refer to Park Brake Cable Service/Adjustment .

Is adjustment within specifications?

--

System OK

--

1. Disconnect the park brake control module connector.
2. Connect a DMM from the park brake linkage travel switch terminal A to park brake control module terminal A6.
3. Measure resistance.

Is the resistance less than the stated value?

<5 ohms

Go to Step 6

Go to Step 9

1. Connect a DMM from the park brake linkage travel switch terminal B to chassis ground.
2. Measure resistance.

Is the resistance less than the stated value?

<5 ohms

Go to Step 7

Go to Step 8

Replace the park brake control module.

Is the repair complete?

--

System OK

--

Locate and repair the open in CKT 150 (BLK) between the park brake linkage travel switch and S107.

Is the repair complete?

--

System OK

--

Locate and repair the open in CKT 1935 (TAN), or CKT 514 (BRN) between the park brake linkage travel switch and the park brake control module.

Is the repair complete?

--

System OK

--