Tools Required

Cooling System Tester

Caution: To help avoid being burned, do not remove the radiator cap while the engine and the radiator are hot. Scalding fluid and steam can be blown out under pressure if the cap is removed too soon.

1. Remove the radiator filler cap, only after the system has cooled.



2. Connect the to the radiator.
3. Apply normal system operating pressure. Never exceed 138 kPa (20 psi).
4. The needle on the tester gauge should remain steady for several minutes, otherwise there is a leak.



5. Examine all cooling system connections and components, including the radiator and the heater, for leaking coolant.
6. Tighten the hose connections or repair as required.



7. Check the radiator cap with the J 24460-01, in order to ensure the correct pressure maintenance. Refer to Radiator Filler Cap Assembly .
8. If the radiator leaks during the pressure test, mark the leak area.

Tools Required

Cooling System Tester

Notice: Do not use boil-out tanks that have been used for copper or brass radiators. The flux and caustic cleaners remaining in these tanks will attack the aluminum radiator causing failure. Use a separate tank containing clean water for servicing aluminum and plastic radiators.

1. Remove the radiator from the vehicle. Refer to Radiator Replacement
2. Clean the radiator core so the damaged area can be seen.

•	Remove dirt and insects from the fins with a common water hose, without the nozzle. Excessive water pressure could damage the fins.

•	Scrub the core with a soft-bristle brush using clean, hot water and a mild detergent.

3. Radiator core leaks can be found by adding water to the radiator.



4. Install test fittings or rubber test caps in the inlet and outlet necks, as shown.



5. Install plugs in the transmission oil cooler fittings to keep dirt out, if equipped.
6. Install plugs in the engine oil cooler fittings, if equipped.



7. Attach the J24460-01 to the radiator.
8. Gradually apply normal system pressure, never exceed 138 kPa (20 psi).
9. The needle on the tester gage will remain steady, if there are no leaks.

•	Help find small leaks by applying soapy water to suspect areas, or submerge the radiator assembly in a large water tank.

•	Check for bubbles at the point of leakage.

10. Damage to a plastic side tank requires replacement.