Was the HVAC Blower Controls System Check performed?

--

Go to Step 2

Go to HVAC Blower Controls System Check

1. Disconnect the blower motor resistor.
2. Connect a test lamp between CKT 63 (TAN) and ground.
3. Turn the ignition switch to the ON position.
4. Turn the engine OFF.
5. Turn the mode selector switch to the HEAT position.
6. Turn the blower switch to the MED-1 position.

Does the test lamp light?

--

Go to Step 4

Go to Step 3

Replace the blower motor resistor. Refer to Blower Motor Resistor Replacement .

Is the repair complete?

--

Go to HVAC Blower Controls System Check

--

Connect a test lamp between CKT 63 (TAN) cavity at the heater and A/C controller connector C4 and ground.

Does the test lamp light?

--

Go to Step 5

Go to Step 6

Locate and repair the open in CKT 63 (TAN).

Is the repair complete?

--

Go to HVAC Blower Controls System Check

--

Replace the heater and A/C controller. Refer to Control Assembly Replacement .

Is the repair complete?

--

Go to HVAC Blower Controls System Check

--