GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 1998 🢒 Jimmy - 2WD 🢒 Body and Accessories 🢒 Instrument Panel, Gauges, and Console 🢒 Sunroof Replacement

Removal Procedure

    Object Number: 306282 Size: SH
  1. Remove the sunroof opening trim.

    2. Start at the butt joint and pull the trim strip from the sunroof opening.

  2. Remove the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.

    3. Object Number: 306286 Size: SH
  3. Remove the sunroof drain hoses from the sunroof assembly.
  4. Disconnect the electrical connectors, as needed.

    5. Object Number: 306287 Size: SH
  5. Remove the bolts that retain the sunroof assembly to the roof.
  6. Remove the nuts that retain the sunroof assembly brackets to the roof.
  7. Release the retainers that secure the sunroof assembly to the roof.
  8. Remove the sunroof assembly from the vehicle.

Installation Procedure

    Object Number: 306287 Size: SH
  1. Install the sunroof assembly to the vehicle.
  2. Use the sunroof retainers in order to secure the sunroof to the roof.

    3. The sunroof retainers are used in order to assist in the assembly of the sunroof at the assembly plant. If a retainer is broken, do not replace the retainer.

  3. Ensure that all broken retainer pieces are removed from the vehicle in order to prevent a rattle noise.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the nuts that retain the sunroof assembly brackets to the roof.

    5. Tighten
    Tighten the nuts to 9 N·m (80 lb in).

  5. Install the bolts that retain the sunroof assembly to the roof.

    6. Tighten
    Tighten the bolts to 9 N·m (80 lb in).


    Object Number: 306286 Size: SH
  6. Install the sunroof drain hoses to the sunroof assembly.
  7. Install the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.

    8. Object Number: 306282 Size: SH
  8. Perform the following steps in order to adjust the sunroof glass, as needed:
    9. 8.1. Loosen the screws that retain the sunroof glass to the sunroof assembly.
    8.2. Secure the sunroof glass in position by tightening the screws.

    Tighten
    Tighten the screws to 3.5 N·m (31 lb in).

       • Adjust the fit between the sunroof glass and the roof opening.
       • The fit should be equal on both sides.
       • Adjust the rear edge of the glass slightly higher than the front edge in order to minimize wind noise.
  9. Open and close the sunroof.
  10. Reinspect the fit of the sunroof glass.