GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 1999 🢒 Jimmy - 2WD 🢒 Engine 🢒 Engine Controls - 4.3L 🢒 Secondary Air Injection Pump Replacement

Removal Procedure

    Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  1. Disconnect the negative battery cable.
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the steering linkage shield. Refer to Steering Linkage Shield Replacement in Steering Linkage (Non-Rack and Pinion).

    4. Object Number: 373100 Size: SH
  4. Remove the AIR injection reactor pipe assembly from the pump assembly by loosening the spring clamp.

    5. Object Number: 379908 Size: SH
  5. Remove the AIR injection reactor pump hose from the pump assembly by loosening the spring clamp.

    6. Object Number: 379909 Size: SH
  6. Disconnect the AIR pump and solenoid electrical connectors.

    7. Object Number: 373107 Size: SH
  7. Remove the AIR pump mounting bolts.

    8. Object Number: 373104 Size: SH
  8. Remove the AIR pump.

Installation Procedure

    Object Number: 373104 Size: SH
  1. Align the AIR pump bracket with the mounting holes.

    2. Object Number: 373107 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the AIR pump mounting bolts.

    3. Tighten
    Tighten the bolts to 17 N·m (13 lb ft).


    Object Number: 379909 Size: SH
  3. Connect the AIR pump and solenoid electrical connectors.

    4. Object Number: 379908 Size: SH
  4. Connect the AIR injection reactor pump hose to the pump assembly with a hose clamp.

    5. Object Number: 373100 Size: SH
  5. Install the AIR injection reactor pipe assembly to the pump assembly with a hose clamp.
  6. Install the steering linkage shield. Refer to Steering Linkage Shield Replacement in Steering Linkage (Non-Rack and Pinion).
  7. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  8. Connect the negative battery cable.