Removal Procedure
- Disconnect the battery negative cable.
- Disconnect the cruise control cable. Refer to Cruise Control Cable Replacement
- Disconnect the electrical connectors, as necessary.
- Remove the 3 nuts that retain the cruise control module to the mounting bracket studs.
- Remove the cruise control module from the mounting bracket.
- Remove the 3 screws that retain the mounting bracket to the cowl panel.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Installation Procedure
- Install the moounting bracket to the cowl panel with the 3 screws.
- Install the cruise control module to the vehicle.
- Install the 3 nuts that retain the cruise control module to the mounting bracket.
- Connect the electrical connectors, as necessary.
- Install the cruise control cable. Refer to Cruise Control Cable Replacement
- Connect the battery negative cable.
- Test the systems operation.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 4.5 N·m (40 lb in).
Tighten
Tighten the nuts to 9.0 N·m (6.6 lb ft).
