For 1990-2009 cars only
Installation Procedure
- Clean the area where the molding or the emblem will be mounted.
- Dry the areas thoroughly.
- Heat the area to a temperature of 27-41°C (80-105°F).
- Ensure that the temperature of the moldings is within 29-32°C (85-90°F). Place the moldings or the emblem, with the adhesive side down, on a heated surface or use a heat gun or a heat lamp.
- Remove the protective liner from the back of the molding or the emblem.
- Apply the molding to the body surface.
- Apply the rear emblem to the body surface.
- Apply the front emblem to the body surface.
- Apply equal pressure along the molding or the emblem in order to uniformly bond the item to the body surface.
Important: Apply emblems in an environment that is free from dust or other dirt that could come in contact with the sticky backing. This may cause improper adhesion.
Use a suitable solvent, such as mixture of 50 percent alcohol and 50 percent water or an equivalent mixture, in order to clean the areas.
