Removal Procedure
- Open and support the hood.
- Disconnect the hood latch cable from the primary latch assembly.
- Remove the clips that retain the hood release cable.
- Remove the hood release cable grommet.
- Remove the body hinge trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Left Side in Interior Trim.
- Remove the hood release cable and the lever bolts from the cowl side panel.
- Remove the hood latch cable assembly from the vehicle.
Use a flat-bladed tool in order to release the clip and lift the cable assembly from the primary latch. In order to aid in installation, tie a mechanic's wire to the end of the cable.
Pry open the clips with a flat-bladed tool.
Guide the cable through the cowl panel underneath the instrument panel from the inside of the vehicle.
Installation Procedure
- Install the hood latch assembly to the vehicle.
- Install the hood release cable and the lever bolts to the cowl side panel.
- Install the hood release cable to the retaining clips.
- Install the hood release cable grommet.
- Install the body hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement - Left Side in Interior Trim.
- Install the hood latch cable to the latch.
- Close the hood.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Guide the cable through the cowl panel underneath the instrument panel from the inside of the vehicle.
Tighten
Tighten the hood release cable and the lever bolts to 9 N·m
(80 lb in).
