GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Tools Required

J 38778 Trim Pad and Garnish Clip Remover

  1. Remove the inside door handle bezel. Refer to Door Inside Handle Bezel Replacement .
  2. Remove the window regulator handle, if equipped. Refer to Door Window Regulator Handle Replacement .
  3. Remove the power accessory switch mounting panel, if equipped with power accessories. Refer to Power Accessory Switch Panel Replacement .

  4. Object Number: 294561  Size: SH
  5. Remove the trim panel armrest screws.
  6. Use the J 38778 in order to release the door trim panel retainers.
  7. Remove the door trim panel from the door.

Installation Procedure


    Object Number: 294561  Size: SH
  1. Install the door trim panel to the door.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the trim panel armrest screws.
  4. Tighten
    Tighten the screws to 1.9 N·m (17 lb in).

  5. Install the power accessory switch mounting plate, if equipped with power accessories. Refer to Power Accessory Switch Panel Replacement .
  6. Install the window regulator handle, if equipped. Refer to Door Window Regulator Handle Replacement .
  7. Install the inside door handle bezel. Refer to Door Inside Handle Bezel Replacement .