Circuit Description
The body control module (BCM) will read an analog voltage from the Passlock sensor. Based on the Passlock internal reference, the BCM will determine if the indicated voltage is 1 of the following conditions:
| • | Open |
| • | Shorted to ground |
| • | A valid code |
| • | A tamper code |
In the case of a tamper code the BCM is reading a tamper code.
Conditions for Setting the DTC
| • | The BCM will inspect for a tamper code when the ignition switch rotates from ON to CRANK. |
| • | The BCM is reading a tamper code from the Passlock sensor for longer than 1.0 seconds. |
Action Taken When the DTC Sets
| • | The vehicle will not run. The security telltale will be flashing. |
| • | The Passlock state is Tamper. |
Conditions for Clearing the DTC
| • | The DTC will clear once an ignition cycle occurs without the fault recurring. |
| • | The BCM history codes will clear after 100 ignition cycles occur without the fault recurring. |
| • | Use a scan tool. |
Diagnostic Aids
| • | Prior to replacing a BCM, ensure that all of the diagnostics have been completed. Refer to Body Control Module Replacement in Body Control Systems. |
| • | Perform a visual inspection of the wiring and the connectors. |
| • | The VTD internal diagnostics are not run while the tamper timer is active. |
Test Description
The numbers below refer to the step numbers on the diagnostic table:
Step | Action | Value(s) | Yes | No | ||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
1 | Did you perform the Theft Deterrent (VTD) Diagnostic System Check? | -- | Go to Step 2 | |||||||||||||||||||||
2 |
Does the scan tool display DTC B3033 as a current DTC? | -- | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections | ||||||||||||||||||||
Inspect the area around the ignition lock cylinder for any device which could create a magnetic field (audio speaker, magnet, etc...) Is there a magnetic device near the ignition lock cylinder? | -- | Go to Step 4 | Go to Step 5 | |||||||||||||||||||||
4 | Remove the device creating the magnetic force. Did you complete the repair? | -- | Go to Step 8 | -- | ||||||||||||||||||||
5 | Inspect for poor connections at the Passlock ™ sensor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 8 | Go to Step 6 | ||||||||||||||||||||
6 | Replace the Passlock™ sensor in the electronic column lock module assembly. Use the appropriate procedure from the following list:
Did you complete the replacement? | -- | Go to Step 7 | -- | ||||||||||||||||||||
7 | Perform one of the following Passlock™ learn procedures:
Is the repair complete? | -- | Go to Step 8 | -- | ||||||||||||||||||||
8 | You may have to wait up to 10 minutes in order to reset the BCM and synchronize all of the Passlock™ components.
Does the DTC reset? | -- | Go to Step 3 | System OK |
