Did you perform the Lighting Systems Diagnostic System Check?

--

Go to Step 2

Go to Diagnostic System Check - Lighting Systems

Verify that the high beam indicator is inoperative.

Does the high beam indicator operate normally?

--

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Turn the ignition switch to the RUN position.
2. Turn the headlamp switch to the HEAD position.
3. Use the Multifunction Switch (Headlamp Dimmer /Flash-to-Pass Switch) to switch on the high beams.

Do the headlamps function properly?

--

Go to Step 4

Go to Symptoms

Using a scan tool, select IPC, Special Functions, and command the high beam indicator Lamp ON, then OFF.

Does the lamp turn ON and OFF when commanded?

--

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 5

1. Inspect for a defective High Beam Indicator bulb. Refer to Instrument Cluster Bulb Replacement in Instrument Panel, Gauges and Console.
2. If the bulb is good, replace the IPC. Refer to Instrument Cluster Replacement in Instrument Panel, Gauges and Console.

Is the repair complete?

--

Go to Step 6

--

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 3