REVISED HEADLAMP SWITCH REPLACEMENT PROCEDURE

VEHICLES AFFECTED: 1984 S/T Light Truck Models

The subject procedure called out in Section 8B, Page 8B-16 of the 1984 'S/T' Series Service Manual is revised as shown below.

Please make note of this change in your copy of the Shop Manual.

Replacement (Refer to Fig. 8B-16)

1. Disconnect battery ground cable.

2. Remove hush panel (over fuse block).

3. Remove hood release handle to I.P. screws.

4. Remove lower steering column trim cover.

5. Remove cruise control module (behind I.P.)

6. Remove wiper delay switch knob and lock nut.

7. Remove headlamp switch knob and shaft.

8. Depress tabs and remove parking brake release handle. Disconnect parking brake cable.

9. Remove headlamp switch bezel.

10. Remove headlamp switch and disconnect electrical connector from switch.

11. Reverse the steps above to install.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.