Accelerator Controls Accelerator Cable Bracket

1. Remove the accelerator cable splash shield attaching screw (1) and splash shield (2) from accelerator cable bracket.
2. Remove the accelerator, cruise and transmission cables, (If so equipped).
3. Remove the accelerator cable bracket attaching bolts and the accelerator cable bracket.

1. Install the accelerator cable bracket with attaching bolts.

Notice: Align the accelerator bracket with the accelerator cam in order to prevent cable wear which could cause the cable to break.

2. Install the bolts to the bracket.

Tighten

•	Tighten the top bolt first.

•	Tighten bolt to 25 N·m (18 lb ft).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the accelerator cable splash shield (2).