GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 188050  Size: SH
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Position a suitable container to catch the engine oil.
  3. Remove the engine oil filter (except Four Wheel Drive vehicle).

  4. Object Number: 3918  Size: SH
  5. Disconnect the engine oil cooler pipes (RWD vehicle) from the oil filter adapter. Refer to Engine Oil Cooler Hose/Pipe Replacement in Engine Cooling.
  6. Disconnect the remote oil filter inlet and outlet hoses (Four Wheel Drive vehicle) from the oil filter pipe adapter. Refer to Remote Oil Filter Adapter Pipe Replacement .

  7. Object Number: 4554  Size: SH
  8. Remove the bolts for the oil filter adapter RWD vehicle or the oil pipe adapter Four Wheel Drive vehicle.

  9. Object Number: 4555  Size: SH
  10. Remove the oil filter adapter and the oil filter adapter gasket.
  11. Discard the oil filter adapter gasket.

  12. Object Number: 4556  Size: SH
  13. Remove the oil filter adapter seal (O-ring).
  14. Discard the oil filter adapter seal (O-ring).
  15. Clean all sealing surfaces.

  16. Object Number: 188026  Size: SH
  17. Remove the oil filter bypass valve.
  18. Clean and inspect valve bore for damage.

Installation Procedure


    Object Number: 188023  Size: SH

    Caution: Wear safety glasses in order to avoid eye damage.

  1. Install a NEW oil filter bypass valve.
  2. 1.1. Install the bypass valve into the oil gallery bore until slightly below flush with the surface of the block.
    1.2. Using a pointed punch, stake the block area around the bypass valve.

    Stake in three locations 120 degrees apart.


    Object Number: 4556  Size: SH
  3. Install a NEW seal (O-ring) into the groove in the oil filter adapter.

  4. Object Number: 4555  Size: SH
  5. Install the oil filter adapter with a NEW oil filter adapter gasket.

  6. Object Number: 4554  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  7. Install the oil filter adapter bolts.
  8. Tighten
    Tighten the oil filter adapter bolts to 21 N·m (15 lb ft).


    Object Number: 3918  Size: SH
  9. Connect the engine oil cooler pipes (RWD vehicle) to the oil filter adapter. Refer to Engine Oil Cooler Hose/Pipe Replacement in Engine Cooling.
  10. Connect the remote oil filter inlet and outlet hoses (Four Wheel Drive vehicle) to the oil filter pipe adapter. Refer to Remote Oil Filter Adapter Pipe Replacement .
  11. Install the engine oil filter (except Four Wheel Drive vehicles). Refer to Engine Oil and Oil Filter Replacement .
  12. Lower the vehicle.