Removal Procedure
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing
any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to
the vehicle or its components.
- Disconnect
the negative battery cable.
- Relieve the fuel pressure. Refer to
Fuel Pressure Relief
.
- Drain the fuel tank. Refer to
Fuel Tank Draining
.
- Lower the fuel tank.
- Remove the fuel tank. Refer to
Fuel Tank Replacement
.
- Disconnect electrical connector.
- Remove the fuel tank pressure sensor (1) from the fuel sender
assembly (2)
Installation Procedure
- Install the fuel vapor
pressure sensor (1) on the fuel sender assembly (2).
- Reconnect electrical connector
- Install the fuel tank. Refer to
Fuel Tank Replacement
.
- Reconnect the negative battery cable.