| Table 1: | Instrument Cluster Scan Tool Data List |
| Table 2: | Instrument Cluster Scan Tool Outputs |
Refer to the below data tables when one of the following conditions exist:
| • | The Instrument Cluster Diagnostic System Check is complete. |
| • | The on board diagnostics are operating correctly. |
| • | No diagnostic trouble codes (DTCs) are displayed. |
The typical scan tool data values are an average of the displayed values recorded from normally operating vehicles. The typical scan tool data values are intended to represent what a normally functioning system would display with certain preliminary settings. The values you get may vary slightly due to a low battery charge or other reasons. But the values should be very close.
Use only the parameters listed in the tables for diagnosis. If a scan tool reads other parameters, the values are not recommended for use in diagnosis. Refer to the Scan tool data definitions for further detailed information.
Typical Scan Tool Data Display
Preliminary Settings: The following preliminary settings must be set in order to achieve the same typical data values listed in the table.
| • | The parking brake is set with the ignition switch in the OFF position (DRL and AHL Disabled). |
| • | The Ignition switch in the RUN position. |
| • | The engine is running. |
| • | The automatic transmission is in the PARK position. |
| • | The manual transmission is in the NEUTRAL position |
| • | The air conditioning is OFF. |
Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
Vehicle Speed | Data | Miles Per Hour (MPH) / Kilometers | 0 MPH |
Module Part number | Module Information | Numeric | XXXXXXXXX (Varies with the vehicle) |
Engine Speed | Data | Revolutions Per Minute (RPM) | 500-700 RPM (Varies with the vehicle) |
Monitored Coolant Temperature | Data | Degrees Fahrenheit (°F) / Celsius (°C) | 190°F (Fluctuates range 180-200°F) 87°C (Fluctuates range 82-93°C) |
Displayed Coolant Temperature | Data | Degrees Fahrenheit (°F) / Celsius (°C) | 190°F (87°C) |
Monitored Fuel Level | Data | Percentage (%) | 0-100% (Varies with the fuel tank level) |
Displayed Fuel Level | Data | Percentage (%) | 0-100% (Varies with the fuel tank level) |
Displayed Odometer Mile | Data | Miles / Kilometers | XXX,XXX Miles (Varies with the mileage of the vehicle) |
Displayed Trip Odometer | Data | Miles / Kilometers | XXX,XXX Miles (Varies with the mileage of the vehicle |
Battery Voltage | Data | Volts | 12.0 - 14.7 Volts (varies with the vehicle) |
PRNDL STATE | Inputs | Park / Reverse / Neutral / Drive / Third / Second / First / Invalid | Park |
Dimming | Inputs | Active / Inactive | Active (when the park lamps are ON) |
Park Switch | Inputs | Open / Closed | Closed |
Trip Reset Switch | Inputs | Active / Inactive | Inactive |
Scan Tool Parameter | Units Displayed | Typical Data Value |
|---|---|---|
|
Important:: The output table shown below does not list all of the instrument cluster LEDs. The instrument cluster LEDs not listed are controlled by a different device. Refer to the applicable device when diagnosing instrument cluster LEDs not shown in the table below. | ||
Low Fuel Lamp | ON/OFF | OFF |
Service 4WD | ON/OFF | OFF |
Overspeed Lamp | ON/OFF | OFF |
ABS Lamp | ON/OFF | OFF |
Brake Lamp | ON/OFF | OFF |
Fasten Seat Belts | ON/OFF | OFF |
Security Lamp | ON/OFF | OFF |
Upshift Lamp | ON/OFF | OFF |
High Beam Lamp | ON/OFF | OFF |
Battery | ON/OFF | OFF |
Tow / Haul | ON/OFF | OFF |
Air Bag Lamp | ON/OFF | OFF |
