Important: The following service procedure is for vehicle equipped with AUTOMATIC TRANSMISSIONS ONLY. Vehicle equipped with manual transmissions are NOT equipped with a transfer case adapters.

1. Remove the transfer case assembly. Refer to Transfer Case Assembly Replacement .
2. Use a suitable transmission jack stand, support the automatic transmission.



3. Remove the transfer case adapter mounting bolts.
4. Remove the transfer case adapter from the transmission.
5. Remove the transfer case adapter seal.



6. Remove the transfer case gasket.

Important: Do not reuse the old gasket if it is damaged, replaced it. Do not use any type of sealer in place of the gasket.

1. Install the new transfer case adapter seal.
2. Install the transfer adapter to the transmission.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the transfer case adapter mounting bolts to the transmission.

Tighten
Tighten the transfer case adapter mounting bolts to 55 N·m (40 lb ft).




4. Install the new transfer case gasket.



5. Install the transfer case assembly. Refer to Transfer Case Assembly Replacement .