GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Notice: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.

  4. Remove the hub and bearing assembly. Refer to Front Wheel Hub, Bearing, and Seal Replacement in Front Suspension.

  5. Object Number: 371033  Size: SH
  6. Remove the splash shield.

Installation Procedure


    Object Number: 371033  Size: SH
  1. Install the splash shield.
  2. Install the hub and bearing assembly. Refer to Front Wheel Hub, Bearing, and Seal Replacement in Front Suspension.
  3. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  4. Lower the vehicle.
  5. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
  6. Slowly release the brake pedal.
  7. Wait 15 seconds, then repeat steps 5-6 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.