GM Service Manual Online
For 1990-2009 cars only

Diagnostic Aids

If the clutch release bearing is noisy with the clutch fully engaged or during engagement, you will also need to inspect the release bearing for burrs and nicks.

Test Description

The number(s) below refer to the step number(s) on the diagnostic table.

  1. This step explains there parts and the operation of the clutch system.

  2. This step inspects for damage or worn parts.

Step

Action

Yes

No

DEFINITION: The clutch release bearing is noisy with the clutch fully engaged or during engagement.

1

Did you review the clutch symptom operations and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Clutch

2

  1. Remove the transmission. Refer to Transmission Replacement in Manual Transmission - 1500.
  2. Inspect the release bearing in the actuator cylinder.

Is the release bearing worn or damaged?

Go to Step 3

Go to Step 4

3

Replace the release bearing in the concentric slave cylinder. Refer to Clutch Concentric Actuator Cylinder Replacement .

Is the clutch release bearing still noisy?

Go to Step 4

System OK

4

Inspect the clutch release bearing or binding on the concentric slave cylinder.

Is the release bearing binding?

Go to Step 5

System OK

5

Check for weak linkage return spring.

Is the return spring weak?

Go to Step 6

System OK

6

Replace the return spring. Refer to Clutch Assembly Replacement .

Did you find and repair the condition?

Go to Step 7

Go to Diagnostic Aids

7

  1. Install the transmission. Refer to Transmission Replacement in Manual Transmission - 1500.
  2. Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 1