Removal Procedure
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• | Unnecessary SIR system repairs |
In order to avoid the above conditions, observe the following guidelines:
• | Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. |
• | If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System. |
- Disable the SIR system.
Refer to
Disabling the SIR System
in
SIR.
- Remove the knee bolster. Refer to
Knee Bolster Replacement
in Instrument Panel, Gauges and Console.
- Loosen the steering column bracket nuts.
- Remove the steering column upper and lower trim covers. Refer
to
Steering Column Trim Covers Replacement - On Vehicle
.
- Disconnect the steering column bulkhead electrical connector from
the vehicle wire harness.
- Remove the wire harness
straps from the steering column wire harness.
- Disconnect the gray and
the black connectors (2) of the switch from the column bulkhead electrical
connector (1).
- Remove the multifunction, turn signal, and hazard switch retaining
screws.
- Remove the multifunction, turn signal, and hazard switch from
steering column.
Installation Procedure
- Install the multifunction,
turn signal, and hazard switch to the steering column.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the multifunction,
turn signal, and hazard switch retaining screws.
Tighten
Tighten the multifunction, turn signal, and hazard switch retaining
screws to 6 N·m (53 lb in).
- Install the multifuntion,
turn signal, and hazard switch electrical connectors (2) to the steering
column bulkhead electrical connector (1).
- Install the steering column
bulkhead electrical connector to the vehicle wire harness.
- Install the wire straps on the steering column wire harness.
- Install the steering column upper and lower trim covers. Refer
to
Steering Column Trim Covers Replacement - On Vehicle
.
- Tighten the steering column bracket nuts.
Tighten
Tighten the steering column bracket nuts to 30 N·m (22 lb ft).
- Install the knee bolster. Refer to
Knee Bolster Replacement
in Instrument Panel, Gauges and Console.
- Enable the SIR system. Refer to
Enabling the SIR System
in SIR.