GM Service Manual Online
For 1990-2009 cars only

Inflatable Restraint Steering Wheel Module Coil Assemble - Off Vehicle Column Shift


    Object Number: 293254  Size: SH
  1. Align the block tooth on the steering shaft assembly (1) to the 12 o'clock position.
  2. Place the ignition switch in the OFF position. Remove the key.

  3. Object Number: 293252  Size: SH
  4. Install the wave washer (1) onto the steering shaft assembly (2).

  5. Object Number: 415291  Size: SH

    Important: A new inflatable restraint steering wheel module coil will be pre-centered. Do not remove the centering tab from the new inflatable restraint steering wheel module coil until the installation is complete.

  6. If reusing the original inflatable restraint steering wheel module coil, refer to Inflatable Restraint Coil Centering - Off Vehicle .
  7. Align the inflatable restraint steering wheel module coil (4) with the horn tower on the turn signal cancel cam assembly (1).
  8. Slide the new inflatable restraint steering wheel module coil (4) onto the steering shaft assembly (2).
  9. Firmly seat the retaining ring (3) into the groove on the steering shaft assembly (2).
  10. Remove and discard the centering tab from the new inflatable restraint steering wheel module coil (4).

  11. Object Number: 415293  Size: SH
  12. Reconnect the inflatable restraint steering wheel module coil connector to the turn signal switch assembly connector.
  13. Attach the wire harness (1) to the wire harness strap (2).
  14. Install the upper and lower trim covers. Refer to Trim Covers, Shift Lever Seal - Assemble - Off Vehicle .

Inflatable Restraint Steering Wheel Module Coil Assemble - Off Vehicle Floor Shift


    Object Number: 293254  Size: SH
  1. Align the block tooth on the steering shaft assembly (1) to the 12 o'clock position.
  2. Place the ignition switch in the LOCK position.

  3. Object Number: 293252  Size: SH
  4. Install the wave washer (1) onto the steering shaft assembly (2).

  5. Object Number: 415291  Size: SH

    Important: A new inflatable restraint steering wheel module coil will be pre-centered. Do not remove the centering tab from the new inflatable restraint steering wheel module coil until the installation is complete.

  6. If reusing the original inflatable restraint steering wheel module coil, refer to Inflatable Restraint Coil Centering - Off Vehicle .
  7. Align the inflatable restraint steering wheel module coil (4) with the horn tower on the turn signal cancel cam assembly (1).
  8. Slide the new inflatable restraint steering wheel module coil (4) onto the steering shaft assembly (2).
  9. Firmly seat the retaining ring (3) into the groove on the steering shaft assembly (2).
  10. Remove and discard the centering tab from the new inflatable restraint steering wheel module coil (4).

  11. Object Number: 415293  Size: SH
  12. Reconnect the inflatable restraint steering wheel module coil connector to the turn signal switch assembly connector.
  13. Attach the wire harness assembly (1) to the steering column wire harness strap (2).
  14. Install the upper and lower trim covers. Refer to Trim Covers, Shift Lever Seal - Assemble - Off Vehicle .