GM Service Manual Online
For 1990-2009 cars only

Electric Park Lock Module - Assemble - Off Vehicle Floor Shift

Tools Required

    • J 41352 Modular Column Holding Fixture
    • J 42640 Steering Column Anti Rotation Pin

    Object Number: 368489  Size: SH
  1. Snap the electric park lock (2) onto the electronic lock module assembly (1).

  2. Object Number: 389654  Size: SH
  3. Install the black connector (2) into the electric park lock (1).

  4. Object Number: 415299  Size: SH
  5. Install the upper trim cover (2) onto the steering column.
  6. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  7. Screw the 2 TORX® head screws (1) into the upper trim cover (2).
  8. Tighten
    Tighten the 2 TORX® head screws to 1.5 N·m (13 lb in).


    Object Number: 328807  Size: SH
  9. Install the lower trim cover onto the upper trim cover in the following way:
  10. 5.1. Match the tab slots on the lower trim cover with the locking tabs on the upper trim cover.
    5.2. Tilt the lower trim cover up.
    5.3. Slide the lower forward until the locking tabs snap into the tab slots.

    Object Number: 415298  Size: SH
  11. Screw the 2 pan head tapping screws (1) into the lower trim cover (2).
  12. Tighten
    Tighten the 2 pan head tapping screws to 3.5 N·m (31 lb in).


    Object Number: 415301  Size: SH
  13. Remove J 42640 from the lower trim cover.
  14. Remove the steering column and J 41352 from the vise.