Tools Required

J 1859-A Steering Wheel Puller

Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

•	Air bag deployment

•	Personal injury

•	Unnecessary SIR system repairs

In order to avoid the above conditions, observe the following guidelines:

•	Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring.

•	If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.

1. Disable the SIR system. Refer to Disabling the SIR System in SIR.
2. Remove the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.



3. Remove the horn plunger from the steering column by pressing inward to the stop and rotating horn plunger 90 degrees.



4. On vehicles with redundant steering wheel controls, disconnect the steering wheel electrical connector.



5. Remove the nut that retains the steering wheel to the steering wheel shaft.
6. Mark the steering wheel to the steering wheel shaft.

This will ensure proper alignment during installation.





Notice: When removing the steering wheel, use only the specified steering wheel puller. Do not hammer on the end of the steering column shaft. Hammering could loosen the plastic injections which maintain the steering column rigidity.

7. Install J 1859-A to the steering wheel.
8. Remove the steering wheel using J 1859-A .
9. Remove the J 1859-A from the steering wheel.

Important: Ensure that the turn signal on the multifunction switch is in the neutral position when installing the steering wheel.

1. Align the mark on the steering wheel and steering shaft.
2. Install the steering wheel to the steering wheel shaft.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the steering wheel retaining nut to the steering shaft.

Tighten
Tighten the nut that retains the steering wheel to the steering shaft to 41 N·m (30 lb ft).




4. On vehicles with redundant steering wheel controls, connect the steering wheel electrical connector.



5. Install the horn plunger to the steering column.
6. Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
7. Enable the SIR system. Refer to Enabling the SIR System in SIR.