Removal Procedure
- Ensure that the headlamp switch is OFF and that
the ignition switch is in the LOCK position.
- Remove the instrument panel accessory trim plate. Refer to
Instrument Panel Accessory Trim Plate Replacement
.
- Disconnect the electrical connector.
- Remove the screws that retain the headlamp switch panel to the
instrument panel accessory trim plate.
- Remove the headlamp switch panel from the instrument panel accessory
trim plate.
Installation Procedure
- Install the headlamp switch panel to the instrument
panel accessory trim plate.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the screws
that retain the headlamp switch panel to the instrument cluster bezel.
Tighten
Tighten the screws to 1 N·m (9 lb in).
- Connect the electrical connector.
- Install the instrument panel accessory trim plate. Refer to
Instrument Panel Accessory Trim Plate Replacement
.