Removal Procedure
Important: The steering column support is not serviceable.
- Remove the instrument panel. Refer to
Instrument Panel Carrier Replacement
.
- Remove the brake switch. Refer to
Stop Lamp Switch Replacement
in Hydraulic Brakes.
- Remove the brake booster pushrod from the brake pedal. Refer to
Power Vacuum Brake Booster Replacement
in Hydraulic Brakes.
- Remove the clutch master cylinder pushrod from the clutch pedal,
if equipped. Refer to
Clutch Pedal Replacement
in Clutch.
- Remove the following steering column support fasteners:
- Remove the brake pedal from the steering column support. Refer
to
Brake Pedal Replacement
in Hydraulic Brakes.
Installation Procedure
- Install the brake pedal
to the steering column support. Refer to
Brake Pedal Replacement
in Hydraulic Brakes.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the steering
column support bracket fasteners.
Tighten
• | Tighten the nuts to 25 N·m (18 lb ft). |
• | Tighten the bolts to 25 N·m (18 lb ft). |
- Install the brake switch. Refer to
Stop Lamp Switch Replacement
in Hydraulic Brakes.
- Install the brake booster pushrod to the brake pedal. Refer to
Power Vacuum Brake Booster Replacement
in Hydraulic Brakes.
- Install the clutch master cylinder pushrod to the clutch pedal,
if equipped. Refer to
Clutch Pedal Replacement
in Clutch.
- Install the instrument panel. Refer to
Instrument Panel Carrier Replacement
.