The number(s) below refer to the step number(s) on the diagnostic table.
Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.
The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.
The presence of either of these codes would indicate an internal module malfunction with the Body Control Module (BCM), inhibiting the operation of the sunroof.
The presence of either of these DTCs will inhibit the battery supply voltage to operate the sunroof system.
Step | Action | Yes | No |
---|---|---|---|
1 | Install a scan tool. Does the scan tool power up? | Go to Step 2 | Go to Scan Tool Does Not Power Up in Data Link Communications |
Does the scan tool communicate with the BCM? | Go to Step 3 | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | |
3 |
Important: The engine may start during the following step. Turn OFF the engine as soon as you have observed the Crank power mode.
Does the ignition switch parameter reading match the ignition switch position for all switch positions? | Go to Step 4 | Go to Power Mode Mismatch in Body Control |
4 | Select the BCM display DTCs function on the scan tool. Does the scan tool display any DTCs? | Go to Step 5 | Go to Symptoms - Roof |
Does the scan tool display any DTCs which begin with a "U"? | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | Go to Step 6 | |
Does the scan tool display DTC B1000? | Go to Diagnostic Trouble Code (DTC) List in Body Control System | Go to Step 7 | |
Does the scan tool display DTC B1477, or B1478? | Go to Diagnostic Trouble Code (DTC) List in Retained Accessory Power | Go to Symptoms - Roof |