GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2001 🢒 Jimmy - 4WD 🢒 Preface 🢒 Cautions and Notices 🢒 Engine Coolant Fan Shroud Replacement

Removal Procedure

    Object Number: 211436 Size: SH
  1. If equipped with the 2.2 L, remove the air intke duct assembly:
    2. 1.1. Loosen the air duct clamps.
    1.2. Remove the air duct rivets (2).
    1.3. Remove the intake duct assembly (1) from the fan shroud (3).

    Object Number: 180301 Size: SH
  2. Remove the upper fan shroud screws.

    3. Object Number: 395858 Size: SH
  3. Disconnect the coolant recovery reservoir hose from the lower fan shroud.
  4. Remove the upper fan shroud.

    5. Object Number: 382732 Size: SH
  5. Lift the lower fan shroud just enough to disengage the locating tabs from the radiator.
  6. Remove the lower fan shroud from the vehicle.

Installation Procedure

    Object Number: 382732 Size: SH
  1. Install the lower fan shroud in the vehicle.
    2. 1.1. Position the lower fan shroud against the radiator.
    1.2. Engage the locating tabs by pushing down on the fan shroud.

    Object Number: 180301 Size: SH
  2. Install the upper fan shroud.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the upper fan shroud attaching screws.

    4. Tighten
    Tighten the screws to 10 N·m (89 lb in).


    Object Number: 395858 Size: SH
  4. Connect the coolant recovery reservoir hose to the lower fan shroud.

    5. Object Number: 211436 Size: SH
  5. If equipped with the 2.2 L, install the sir intake duct assembly:
    6. • Loosen the air duct clamps.
    • Remove the air duct rivets (2).
    • Remove the intake duct assembly (1) from the fan shroud (3).
    • Install the intake air ducts.

    Tighten
    Tighten the intake air duct clamps 5 N·m (44 lb in).

    • Install the rivets (2).