For 1990-2009 cars only
Removal Procedure
- Release the parking brake, if applied.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the park brake equalizer. Refer to Park Brake Cable Equalizer Replacement .
- Using the J 37043 (1), collapse the locking tabs on the park brake cable.
- Remove the park brake cable from the mounting bracket.
- Remove the cable mounting bolts for the mounting bracket.
- Remove the park brake cable mounting bracket.
Installation Procedure
- Install the park brake cable mounting bracket.
- Install the park brake cable mounting bracket bolt.
- Install the rear cables to the mounting bracket by inserting the cable till all the retaining tabs snap into place.
- Install the park brake equalizer. Refer to Park Brake Cable Equalizer Replacement .
- Adjust the park brake. Refer to Park Brake Adjustment .
- Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the mounting bracket bolt to 17 N·m (13 lb ft).
