For 1990-2009 cars only
Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Support the vehicle with safety stands.
- Disconnect the backup lamp switch electrical connector.
- Remove the backup lamp switch.
Installation Procedure
- Install the backup lamp switch.
- Connect the backup lamp switch electrical connector.
- Lower the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
The backup lamp switch has pre-applied thread sealant on the threads.
Tighten
Tighten the backup lamp switch to 37 N·m (28 lb ft).
