Removal Procedure
Important: The ignition switch should be in the OFF position when connecting or
disconnecting the connectors to the BCM. Always disconnect the Brown BCM connector
FIRST and connect the Brown BCM connector LAST. The BCM can set DTC(s)
with the ignition switch in the OFF position.
- Remove the left instrument
panel sound insulator from the vehicle. Refer to
Instrument Panel Insulator Panel Replacement - Left Side
in Instrument Panel,
Gages and Console.
- Remove the lower instrument panel sound insulator from the vehicle.
Refer to
Instrument Panel Insulator Panel Replacement
in Instrument Panel, Gages and Console.
- Disconnect the electrical connectors from the body control module.
- Bend the 2 snap retainers back slightly and pull the body
control module from the bracket at an angle.
Installation Procedure
- Install the body control
module to the bracket at an angle under the wide hook retainer, with the label
facing away from the bracket.
- Apply pressure on the left side of the body control module in
order to move the module toward the mounting bracket base. Snap the module
into place.
- Ensure that the module is fully seated. Ensure that both snap
retainers are holding the module.
- Connect the electrical connectors to the body control module.
Be sure to connect the brown connector last.
- Install the lower instrument panel sound insulator to the vehicle.
Refer to
Instrument Panel Insulator Panel Replacement
in Instrument Panel, Gages and Console.
- Install the left instrument panel sound insulator to the vehicle.
Refer to
Instrument Panel Insulator Panel Replacement - Left Side
in Instrument Panel, Gages and Console.
- Use the following components in order to program the body control
module with the proper calibrations:
- Perform the BCM Programming. Refer to
Body Control Module (BCM) Programming/RPO Configuration
.
- Clear the diagnostic trouble codes (DTCs).