ROUGH IDLE/COLD START STALL NEW CALIBRATION PROM

SUBJECT: ROUGH IDLE/STALL AFTER COLD START (NEW CALIBRATION PROM)

VEHICLES AFFECTED: 1988-90 S/T TRUCK W/4.3L AUTOMATIC TRANSMISSION

APPLICATION:

------------ 1988-90 4.3L Automatic S/T Truck W/Federal Emission (NA5)

CONDITION:

---------- Some of the above trucks may exhibit a rough idle, sag or stalling condition after cold start-up at intermediate ambient temperatures of 0-210C. This condition may be most noticeable while performing a Park to Drive/Reverse shift. The condition improves as the engine reaches normal operating temperature.

CAUSE:

------ The condition is due to low idle speeds and/or lean air/fuel ratios after cold start-up.

CORRECTION:

----------- To correct this condition, install a new service calibration PROM which revised warm-up idle speeds. The new PROM will also raise the normal controlled idle speed from 500 RPM in drive. Reference the chart below for the proper PROM application.

SERVICE PROM BROADCAST SERIES ENGINE TRANS EMISS PROM P/N ID CODE ------ ------ ----- ------- --------- ----- ---------- S/T 4.3 Auto FED/ALT 16147593 3151 ATBA (NA5/NA6)

Note: These PROMs were released to production as follows: The Federal PROM is in all 1991 models.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.