SEAT BELT HITS DOOR PANEL INSTALL SHOULDER BELT CLIP

MODELS: 1985-86 M VANS EQUIPPED WITH HIGH BACK RECLINER BUCKET SEATS

Some 1985-86 M vans may experience a condition of over retraction of the shoulder belt when the seat is not occupied. This may result in the seat belt buckle stopping six to ten inches from the retractor housing with the blade facing the door. The blade may then penetrate the interior trim panel when exiting the vehicle and the door is closed. This condition may be corrected by installing a shoulder belt stop clip consisting of two identical pieces of plastic. To install the clip, the seat must be adjusted completely rearward. The seat belt must be retracted so that the tongue end of the lap belt is parked into the seat belt guide alongside the seat. Snap the two pieces together around the shoulder belt webbing so that they are contacting the retractor cover. The clip will prevent the shoulder belt from retracting past that point.

Parts Information

Part Number Color Quantity ----------- ----- -------- 15584746 Lt. Saddle 2 15584747 Med. Teal Blue 2 15584748 Dk. Maple 2 15584749 Dk. Gray 2

A shoulder belt stop button was incorporated for SOP 1987.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.