SMU-SECTION 10A2 SEAT BELT- NEW CHILD SEAT TETHER LOCK

SUBJECT: SERVICE MANUAL UPDATE SECTION 10A2, SEAT BELT NEW CHILD SEAT TETHER LOCATION (SECOND SEAT POSITION)

VEHICLES AFFECTED: 1990-93 "M/L" VANS

The following represents new information for Child Restraint Tether Location for 1990-93 "M/L" Vans.

CHILD RESTRAINT TETHER BELT LOCATION SECOND SEAT BUCKET (Extended Van)

Use figure 1 to determine the location of the tether belt hole. To install the anchor plate, cut the carpet or mat and the installation so that the anchor plate sits on the floor panel sheet metal.

Drill a 10.0 mm (3/8 inch) hole in the floor pan at the proper location.

INSTALL

1. An M8 bolt or equivalent through the anchor plate and the floor pan.

2. A medium bodied sealer around the cleaned hole at the underside of the floor panel.

3. A 62 mm (2 7/16 inch) diameter by 3 mm (1/8 inch) flat washer.

4. Nut

TIGHTEN

Nut 27 N.m (20 lbs. ft.).

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.