Did the Remote Keyless Entry System Check bring you here?

--

Go to Step 2

Go to Remote Keyless Entry System Check

1. Disconnect the remote control door lock receiver.
2. Move either power door lock switch to the LOCK position.
3. Connect a fused jumper from the remote control door lock receiver CKT 1095 (TAN) cavity G to ground.
4. Keep the jumper connected for the remainder of this test.

Does the rear power door lock motor lock?

--

Go to Step 3

Go to Step 5

Replace the remote control door lock receiver Receiver Replacement .

Is the replacement complete?

--

Go to Step 4

--

Reprogram the replacement remote control door lock receiver to the transmitter. Refer to Transmitter Programming .

Is the reprogramming complete?

--

Go to Remote Keyless Entry System Check

--

1. Disconnect the rear door lock motor connector.
2. Place either power door lock switch in the LOCK position.
3. Connect a test lampJ 35616-200 from CKT 295 (GRY) cavity B to ground.

Does the test lamp light?

--

Go to Step 6

Go to Step 7

1. Place either power door lock switch in the LOCK position.
2. Connect a test lampJ 35616-200 between CKT 294 (TAN) cavity A and CKT 295 (GRY) cavity B at the rear door lock motor.

Does the test lamp light?

--

Go to Step 8

Go to Step 9

Repair the open in CKT 295 (GRY) between the rear door lock motor and splice S228.

Is the repair complete?

--

Go to Remote Keyless Entry System Check

--

Replace the rear door lock motor Lock Replacement - Rear Door Remote .

Is the replacement complete?

--

Go to Remote Keyless Entry System Check

--

Repair the open in CKT 294/1095 (TAN) from the rear door lock motor connector to the remote control door lock receiver connector.

Is the repair complete?

--

Go to Remote Keyless Entry System Check

--