For 1990-2009 cars only
Removal Procedure
- Use a wax or a grease pencil in order to mark the position of the bracket on the door.
- Unsnap the lower corner of the door trim panel to expose the bracket (2) to door bolts.
- Support the bottom of the door.
- Remove the bracket (2) to door bolts (5).
- Slide the bracket (2) out of the rear of the track in order to remove the bracket from the body.
Installation Procedure
- Slide the bracket rollers (2) into the rear of the track in order to install the bracket to the body.
- Align the bracket with the marks made during removal in order to install the bracket to the door.
- Install the bolts that retain the bracket to the door.
- Remove the support from the bottom of the door.
- Snap the lower corner of the door trim panel back in place.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bracket retaining bolts to 25 N·m (18 lb ft).
