GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 1998 🢒 Safari - 2WD 🢒 Body and Accessories 🢒 Doors 🢒 Rear Side Door Center Roller Bracket Replacement

Removal Procedure
  1. Remove the center roller track cover. Refer to Rear Side Door Center Track Cover Replacement .

    2. Object Number: 324152 Size: SH
  2. Position the sliding door inward for door clearance.

    3. Remove the bolts (5) that retain the center roller bracket (2) to the door.

  3. Unsnap the retaining spring located around the pin to release it.
  4. Support the sliding door at the bottom rear corner.
  5. Slide the bracket rearward.
  6. Remove the bracket (2) from the center roller track.

Installation Procedure
  1. Install the bracket (2) to the center roller track.
  2. Slide the bracket forward.
  3. Remove the support from the sliding door.
  4. Snap the retaining pin back in place.

    5. Check that the retaining spring located around the pin for damage, if damaged replace it.

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 324152 Size: SH
  5. Install the bolts (5) that retain the center roller bracket to the door.

    6. Tighten
    Tighten the center roller bracket retaining bolts to 35 N·m (26 lb ft).

  6. Install the center roller track cover.