Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

1. Remove the C and the D pillar trim. Refer to Third Pillar Trim Replacement - Right Side and Fourth Pillar Trim Replacement - Left Side .
2. Remove the jack access panel.
3. Remove the upper and the lower belt anchors. Refer to Rear Seat Belt Replacement in Restraints.
4. Remove the cargo net bolt.
5. Remove the screw that retains the panel to the C pillar.



6. Use the J 38778 in order to release the fasteners that retain the panel to the vehicle.

1. Install the panel to the vehicle:

1.1.	Align the retaining clips with the holes in the body.

1.2.	Press the panel down in order to seat the fasteners into place.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the screw that retains the panel to the C pillar.

Tighten
Tighten the screw that retains the panel to the C pillar to 2 N·m (18 lb in).

3. Install the cargo net bolt.

Tighten
Tighten the cargo net bolt to 2 N·m (18 lb in).

4. Install the jack access panel.
5. Install the upper and the lower mounting bolts for the rear seat belt.
6. Install the C and the D pillar trim. Refer to the appropriate procedure:

•	Third Pillar Trim Replacement - Right Side

•	Fourth Pillar Trim Replacement - Left Side