Inflatable Restraint Steering Wheel Module Coil Assemble - Off Vehicle for GMC Truck Safari - 2WD 2001

1. Align the block tooth on the steering shaft assembly (1) to the 12 o'clock position.
2. Place the ignition switch in the OFF position. Remove the key.



3. Install the wave washer onto the steering shaft assembly.




Important: A new inflatable restraint steering wheel module coil will be pre-centered. Do not remove the centering tab from the new inflatable restraint steering wheel module coil until the installation is complete.

4. If reusing the original inflatable restraint steering wheel module coil, refer to Inflatable Restraint Steering Wheel Module Coil Assemble - Off Vehicle .
5. Align the inflatable restraint steering wheel module coil (4) with the horn tower on the turn signal cancel cam assembly (1).
6. Slide the inflatable restraint steering wheel module coil (4) onto the steering shaft assembly (2).
7. Firmly seat the retaining ring (3) into the groove on the steering shaft assembly (2).
8. Remove and discard the centering tab from the new inflatable restraint steering wheel module coil (4).



9. Install the wire harness strap (2) into the steering column tilt head assembly (1).
10. Install the wire harness straps (3) onto the wire harness assembly (4).
11. Install the wire harness assembly (4) into the wire harness strap (5).
12. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .