For 1990-2009 cars only
Removal Procedure
- Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim.
- Remove the oil level indicator.
- Remove the bolt holding the oil level indicator tube to the transmission fluid fill tube.
- Remove the upper half of the oil level indicator tube from the lower half.
- Clean the old sealer from the tube.
- Remove the oil level indicator tube bolt.
- Remove the oil level indicator tube from the engine using a twisting motion.
- Clean the old sealer from the oil level indicator tube and the engine block.
Installation Procedure
- Install the lower half of the oil level indicator tube to the engine. Refer to Oil Level Indicator and Tube Installation .
- Apply sealer, GM P/N 12346004 (Canadian P/N 10953480) or equivalent, on the upper oil level indicator tube to the area where the tube fits into the lower half.
- Install the oil level indicator tube upper half to the lower half.
- Secure the engine oil level indicator tube to the transmission fluid fill tube with the bolt.
- Install the oil level indicator.
- Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolt to 12 N·m (106 lb in).
