Circuit Description
Tow/haul mode enables the operator to achieve enhanced shift performance when towing or hauling a load. When tow/haul mode is selected, the tow/haul switch input signal to the body control module (BCM) is momentarily toggled to zero volts. This signals the powertrain control module (PCM) to extend the length of time between upshifts and increase transmission line pressure. Cycling the tow/haul switch again disables tow/haul mode and returns the transmission to a normal shift pattern.
Test Description
The numbers below refer to the step numbers on the diagnostic table.
-
This step tests for a faulty tow/haul switch.
-
This step tests for voltage input from the BCM to the tow/haul switch.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 |
Does the scan tool display Active when the switch is first pressed, and then Inactive when the switch is pressed again? | -- | Go to Intermittent Conditions in Engine Controls | Go to Step 2 |
Important: The tow/haul switch is connected to the steering column harness. Does the scan tool Tow/Haul Mode indicate a status change? | -- | Go to Step 7 | Go to Step 3 | |
Using the DMM and the J 35616-A GM Terminal Test Kit, measure the voltage at terminal A9 of the I/P wiring harness connector (C201). Is ignition voltage measured? | -- | Go to Step 6 | Go to Step 4 | |
4 | Using the DMM and the J 35616-A , measure the voltage at terminal C1-B12 of the body control module (BCM). Is ignition voltage measured? | -- | Go to Step 5 | Go to Step 8 |
5 | Test the signal circuit of the tow/haul switch for an open or shorted condition. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 9 | Go to Intermittent Conditions in Engine Controls |
6 | Test the ground circuit of the tow/haul switch for an open or shorted condition. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 9 | Go to Intermittent Conditions in Engine Controls |
7 | Replace the tow/haul switch. Refer to Shift Lever Replacement in Steering Wheel and Column. Did you complete the replacement? | -- | Go to Step 9 | -- |
8 | Test the BCM for proper operation. Refer to Diagnostic Starting Point - Body Control System in Body Control System. Did you find and correct the condition? | -- | Go to Step 9 | -- |
9 | After the repair is complete, observe Tow/Haul Mode on the scan tool display, while cycling the tow/haul switch. Does the scan tool display Active when the switch is first pressed, and then Inactive when the switch is pressed again? | -- | System OK | Go to Step 1 |
