TRANSMISSION OIL COOLER/OUTLET FITTINGS SEPARATOR TOOL

SUBJECT: TRANSMISSION OIL COOLER/OUTLET FITTINGS SEPARATOR TOOL (SERVICE INFORMATION)

VEHICLES AFFECTED: 1990 L VANS W/AUTOMATIC TRANSMISSIONS

During major component removal, a separator tool should be used to remove and replace the transmission oil cooler inlet and outlet pipe limes from the quick connect fittings located at the radiator on the above subject vehicles.

Because access is limited to the transmission oil cooler inlet and outlet fittings at the radiator, fitting removal from the radiator is difficult, refer to Figure 1. Use of a separator tool allows easier removal of the pipe lines and aids in preventing possible pipe/line fitting damage.

Kent-Moore has available a fuel line quick connect separator currently used in the automobile industry that can also be utilized for removal and replacement of the transmission oil cooler pipes on 1990 L vans equipped with automatic transmissions.

TOOL INFORMATION: (Refer to Figure 2).

Kent-Moore Separator Part Number - J37088-2A

TOOL PROCUREMENT:

Kent-Moore Tool Division 29784 Little Mack Roseville, MI 48066-2298 Telephone (313) 774-9500 (USA) (416) 624-6295 (Canada)

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.