GM Service Manual Online
For 1990-2009 cars only

SERVICE MANUAL UPDATE- SEC 3C TORSION BAR REPLACEMENT (REV)

SUBJECT-. TORSION BAR ASSEMBLY REPLACEMENT

MODELS: 1992 M/L

The following represents revised information for Section 3C of the 1992 M/L Models Service Manual, X-9230.

This procedure supplements the information found under "Torsion Bar(s) and Support Assembly Replacement" on pages 3C-33 and 3C-34 of the 1992 M/L Models Service Manual, X-9230.

TORSION BAR ASSEMBLY REPLACEMENT

Remove or Disconnect (Figure 48)

Tool Required:

J 22517-C Torsion Bar Unloading Tool

1. Raise vehicle and support with safety stands. 2. Adjustment assemblies on torsion bar. A. Mark the adjustment bolt (184) setting. B. Increase the tension on the adjustment arm (186) using J 22517-C. C. Remove adjustment bolt (184) and retaining plate (1 85). D. Move the tool aside. 3. Torsion bar anchor adapter. A. Slide the adapter out toward the rear. B. Remove the adjustment arm (186). 4. Torsion bar (182). Note the location of the tape at the rear ends of the torsion bars. There are different bars for the left and right sides. Install or Connect (Figure 48)

Tool Required:

J 22517-C Torsion Bar Unloading Tool

1. Torsion bar (182). Note the location of the paint stripe at the rear end of the torsion bars. There are different bars for the left and right sides. Make sure the bars (182) are on their respective sides. 2. Torsion bar anchor adapter (188). A. Install adjustment arm (186). B. Slide adapter tube (188) over torsion bar (182) and into adjustment arm (186). C. Make sure adapter tube is properly seated into the front face of crossmember and torsion bar is properly seated into rear of the adapter tube. D. The leading edge of the paint stripe (177) must not extend past the front of the frame crossmember (1 75). 3. Adjustment retainer plate (185 and bolt (184). A. Increase the tension on the torsion bar using J 22517-C. B. Install the retaining plate and adjustment bolt. C. Set the adjustment bolt to the marked setting from step 1 of the removal procedure. D. Release the tension on the torsion bar until the load is taken up by the adjustment bolt. E. Remove J 22517-C. 4. Lower the vehicle 5. Check the "Z" height. Refer to SECTION 3A.


Object Number: 81280  Size: FS

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.