For 1990-2009 cars only
Removal Procedure
- Remove the interior garnish moldings. Refer to Rear Side Door Garnish Molding Replacement .
- Pull the weatherstrip from the body flange, starting at the upper right corner (6,5,4,3,2,1).
Installation Procedure
- Partially attach the weatherstrip to the body flange in six areas (1,2,3,4,5,6):
- Ensure that the following conditions are met:
The weatherstrip length is equally distributed around the door opening.
| 1.1. | Seat the weatherstrip onto the body flange to approximately 154 mm (6 in) on each side of the corner in order to install the weatherstrip at the corner. |
| 1.2. | Fit the weatherstrip to the opening by hand. |
| Important: When using the rubber mallet, it is critical that the weatherstrip be hit square to the flange. Otherwise, an undesirable spreading of the carrier will occur and result in reduced retention. |
| 1.3. | Use a rubber mallet in order to install the thick flange areas of the hinge and the windshield pillars, and in each corner. |
| • | The weatherstrip fits into the corner and matches the radius of the body flange. |
| • | The weatherstrip is seated completely onto the flange in all areas, resulting in a smooth vinyl trim around the entire door opening. |
| • | There is no distortion or excessive spreading of the carrier as a result of hitting the carrier improperly with the rubber mallet. |
| • | The weatherstrip is not kinked or distorted after installation. |
| • | The weatherstrip is lubricated with GM weatherstrip silicone lube. Refer to Fluid and Lubricant Recommendations in Maintenance and Lubrication. |
