GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the trim panel. Refer to Rear Door Trim Panel Replacement .
  2. Separate the water deflector at the perforations. Use a sharp-bladed tool for proper access, if needed.

  3. Object Number: 324229  Size: SH
  4. Remove the control rods from the remote lock.
  5. 3.1. Pry the clip anchor out of the hole.
    3.2. Push the clip away from the lever.
    3.3. Pull the rod and the clip away from the lever.

    Object Number: 324199  Size: SH
  6. Remove the remote lock nuts.
  7. Remote the lock.

Installation Procedure


    Object Number: 324199  Size: SH
  1. Install the clips to the remote lock.
  2. Install the remote lock.
  3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the remote lock nuts.
  5. Tighten
    Tighten the remote lock nuts to 7 N·m (62 lb in).


    Object Number: 324229  Size: SH
  6. Install the control rods through the clips to the remote lock.
  7. Install the water deflector. Refer to Water Deflector Replacement .
  8. Install the trim panel. Refer to Rear Door Trim Panel Replacement .