GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2000 🢒 Safari - 4WD 🢒 Engine 🢒 Engine Exhaust 🢒 Exhaust Muffler Replacement

Removal Procedure

Caution: Always wear protective goggles and gloves when removing exhaust parts as falling rust and sharp edges from worn exhaust components could result in serious personal injury.

Caution: In order to avoid being burned, do not service the exhaust system while it is still hot. Service the system when it is cool.

An accumulation of dirt and corrosion may make removing exhaust components difficult. Applying a penetrating oil on the threads of the bolts may assist in the removal of these components.

  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Support the muffler assembly.

    3. Object Number: 84636 Size: SH
  3. Remove the three nuts connecting the muffler assembly to the catalytic converter assembly.

    4. Object Number: 163857 Size: SH
  4. To aid in the removal of the muffler assembly, lubricate the rubber hangers with rubber lubricant GM P/N 12345884.

    5. Remove the muffler assembly from the front hanger.


    Object Number: 475677 Size: SH
  5. Remove muffler assembly from the rear hanger.

    6. Object Number: 163862 Size: SH
  6. Remove the muffler assembly from the tailpipe hanger.
  7. Remove the muffler assembly from the vehicle.

Installation Procedure

When installing exhaust components, inspect the exhaust system for proper alignment. Misaligned components commonly cause rattles, noise and vibrations in the exhaust system. During system alignment, leave all of the bolts or nuts loose, until all of the parts are properly aligned. After properly aligning the parts, tighten the bolts or nuts from the front to the rear.

In order to maintain the alignment of the exhaust system, replace any damaged exhaust system hangers, hanger brackets, and clamps.

Important: 

   • Replacement of exhaust system parts must be OEM standard to ensure that the vehicle operates as designed.
   • Replace the tailpipe when replacing the muffler.
   • Always use new nuts when installing the exhaust pipe to the exhaust manifold.
   • Before installing the new nuts, clean the exhaust manifold stud threads with a wire brush.


    Object Number: 163862 Size: SH
  1. To aid in the installation of the muffler assembly, lubricate the rubber hangers with rubber lubricant GM P/N 12345884.

    2. Install the muffler assembly into the vehicle.

  2. Connect the muffler assembly to the tailpipe hanger.

    3. Object Number: 475677 Size: SH
  3. Connect the muffler assembly to the rear hanger.

    4. Object Number: 163857 Size: SH
  4. Connect muffler assembly to the front hanger.

    5. Object Number: 84636 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the three nuts to connect the muffler assembly to the catalytic converter assembly.

    6. Tighten
    Tighten the nuts to 40 N·m (30 lb ft).