Windshield Wiper System Module Replacement Rear

1. Remove the liftgate garnish molding. Refer to Liftgate Garnish Molding Replacement .
2. Disconnect the two electrical connectors from the controller module assembly.
3. Drill the heads from the rivets with an appropriate drill bit.
4. Remove two rivets and the controller assembly from the liftgate.

1. Install the controller module assembly onto the liftgate.
2. Install two new rivets with a hand-held rivet gun.
3. Connect the two electrical connectors to the controller assembly.
4. Install the liftgate garnish molding. Refer to Liftgate Garnish Molding Replacement .

Windshield Wiper System Module Replacement Front

1. Remove the wiper motor electrical connector.
2. Remove the cover screws.
3. Remove the cover.
4. Remove the circuit board and terminal module by lifting up on the terminal.

1. Install the circuit board and terminal module.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the cover and 3 screws.

Tighten
Tighten the screws to 2.6 N·m (23 lb in).

3. Install the wiper motor electrical connector.